Michigan Manufacturing Technology Center To Unveil New Lightweight Frame for Specialty Cars at 2017 SEMA Show
[ Back ]   [ More News ]   [ Home ]
Michigan Manufacturing Technology Center To Unveil New Lightweight Frame for Specialty Cars at 2017 SEMA Show

PLYMOUTH, Mich., Oct. 24, 2017 — (PRNewswire) — The Michigan Manufacturing Technology Center announced today plans to unveil their newly engineered lightweight aftermarket frames at the 2017 SEMA Show in Las Vegas, Nev., Oct. 31-Nov. 3. Show attendees will be the first to see models of the lightweight alternative for replacing frames on nearly any specialty vehicle. Although not yet in production, this forward-looking engineering could give specialty car owners access to an affordable, stiffer and safer car frame option in the future.

The Center, a representative of the MEP National Network, collaborated with Lightweight Innovations for Tomorrow, The Institute for Advanced Composites Manufacturing Innovation and the University of Tennessee, Center for Industrial Services Institute for Public Service to create the frame. Although multiple lightweight materials are integrated into the frame's design, the engineering and design team was able to keep the cost comparable to current production steel frames.

"A key objective for showing our new car frame at SEMA is to gauge industry interest in the lightweight frame as we look to commercialize the design next year," said Michael Coast, President, Michigan Manufacturing Technology Center.

SEMA attendees can visit The Center's booth 51734 to see a small-scale model of a C2 Corvette (1963 to 1967) lightweight alternative frame. Engineers chose the C2 Corvette as a baseline because of its popular body style and well-engineered original frame. Engineers involved with the project use morphing software to allow the lightweight frame to be configured to fit virtually any body width and length.

"The frame's construction is not only strong and cost-efficient, it's nearly 90 pounds lighter than the C2 Corvette baseline," Gregg Peterson, Principle Materials Engineer, Michigan Manufacturing Technology Center. "We look forward to bringing this innovative design to specialty car manufacturers and restorers in the future and showcasing models to industry peers at SEMA this year."

The C2 Corvette alternative lightweight frame is 150 percent stiffer in torsion and 450 percent stiffer in bending than the baseline C2 production frame. It requires no welding so the parent material is not weakened during assembly and allows for thinner section material, reducing material cost. The frame is joined using structural adhesives and mechanical fasteners; the adhesive bonds 100 percent of the flange which spreads the loads out over a larger area than a typical spot weld. This uniformly distributes the forces and reduces local stresses, meaning thinner wall materials, further reducing material weight and cost. The self-fixturing design also eliminates the need for jig fixtures.

To learn more about the lightweight aftermarket frames, visit: www.the-center.org/lightweight-frames.   

About Michigan Manufacturing Technology Center
Since 1991, the Michigan Manufacturing Technology Center has assisted Michigan's small and medium-sized businesses to compete and grow. The Center is celebrating a quarter century of building super highways of competitive success for their clients, where there were once only slow and lonely dirt roads. Now, they stand ready to face the future with bountiful optimism, focused purpose, strong determination, legions of support staff and inspired creativity. For additional information, visit www.the-center.org.

 

View original content: http://www.prnewswire.com/news-releases/michigan-manufacturing-technology-center-to-unveil-new-lightweight-frame-for-specialty-cars-at-2017-sema-show-300542075.html

SOURCE Michigan Manufacturing Technology Center