Toshiba Expands Line-up of ARM® Cortex®-M3-based Microcontroller for Smart Meters

TOKYO — (BUSINESS WIRE) — March 11, 2015Toshiba Corporation (TOKYO:6502) today announced the launch of a new microcontroller, “TMPM311CHDUG”, as the latest addition to its ARM® Cortex®-M3-based TX03 series. The microcontroller is designed for smart meter applications. Sample shipments will start in April, with mass production scheduled to start in September, 2015.

Toshiba: ARM(R) Cortex(R)-M3-based microcontroller "TMPM311CHDUG" for smart meters. (Photo: Business ...

Toshiba: ARM(R) Cortex(R)-M3-based microcontroller "TMPM311CHDUG" for smart meters. (Photo: Business Wire)

A power measurement analog front-end (AFE) for single-phase and three-phase smart meters requires simultaneous high-precision current measurement, voltage measurement and power calculation. A 24-bit delta-sigma(∆Σ)-type AD converter incorporated in the new product enables high-precision current measurement, voltage measurement and power calculation at the same time. This ensures the realization of high-end smart meters.

Applications
Smart meters
Measuring equipment

Key Features of New Products
-Built-in four-channel 24-bit ΔΣ-type AD converter: Measures current and voltage simultaneously, with high precision. The allowance for measurement error of single-phase power calculation is within 0.1 %.
-Three-phase power meter solution: Simultaneous current and voltage measurement for up to eight channels is supported by using two units of the microcontroller in an interlocking manner.
-Built-in low-noise variable gain amplifier in each conversion channel of the 24-bit ΔΣ-type AD converter: Enables high-precision measurement for current from a current sensor. This supports both power calculation meter and various sensor equipment.
-Built-in temperature sensor: Enables various temperature corrections.
-In combination with “TMPM411F20”, which incorporates two Cortex-M4F cores and performs measurement and communication controls on one chip, and enables tamper detection in the power failure and interrupt detection for measurement and communications at super-low power consumption, “TMPM311CHDUG” can realize a smart meter system that integrates measurement and communication on a board.

 

Specifications

Part number   TMPM311CHDUG
Sample price (tax included) 300 yen
Main

specifications

  CPU ARM® Cortex®-M3
Maximum frequency 20MHz
Internal memory SRAM 21 Kbytes
Operating voltage 2.7 to 3.6 V
24-bit ∆Σ AD converter

4 ch

• Built-in variable gain amplifier for each channel

Variable gain: x1, x2, x4, x8, x16

• 1 channel is also used as an input of the internal temperature sensor.

μDMA controller 1 unit
16-bit timer 5 ch
Interrupt input 2 ch
SSP 1 ch
SIO/UART 1 ch
Temperature sensor 1 ch
Package LQFP48 (7mm x 7mm, 0.5mm pitch)
Note   DMA: Direct Memory Access
1 Kbyte is calculated as 1024 bytes.
 

1 | 2  Next Page »
Featured Video
Latest Blog Posts
Bob Smith, Executive DirectorBridging the Frontier
by Bob Smith, Executive Director
ESD Alliance Member Companies at DAC
Jobs
Senior DPU System Application Engineer for Nvidia at Santa Clara, California
Senior Post Silicon Hardware Engineer for Nvidia at Santa Clara, California
Senior Hardware Engineer IV – CA for Ampex Data Systems Corporation at Hayward, California
Design Verification Engineer for Blockwork IT at Milpitas, California
Upcoming Events
SemiconWest - 2024 at Moscone Center San Francisco CA - Jul 9 - 11, 2024
Flash Memory 2024 Conference & Expo FMS2024 at Santa Clara Convention Center Santa Clara CA - Aug 6 - 8, 2024
SEMICON Taiwan 2024 at Taipei Nangang Exhibition Center Taipei Taiwan - Sep 4 - 6, 2024



© 2024 Internet Business Systems, Inc.
670 Aberdeen Way, Milpitas, CA 95035
+1 (408) 882-6554 — Contact Us, or visit our other sites:
AECCafe - Architectural Design and Engineering TechJobsCafe - Technical Jobs and Resumes GISCafe - Geographical Information Services  MCADCafe - Mechanical Design and Engineering ShareCG - Share Computer Graphic (CG) Animation, 3D Art and 3D Models
  Privacy PolicyAdvertise